Frymaster CF Series - Manual (Page 22)

CF SERIES GAS FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
3-3
LIGHTING THE PILOT ON FRYERS WITH CE HONEYWELL GAS VALVES
1. Ensure power to the unit is OFF, and then press the OFF (red) button. Wait 5 minutes.
2. Place a flame near the pilot assembly, push and hold the PILOT (white) button in, light the pilot,
and continue to depress the button for at least 60 seconds after the pilot lights. Failure to hold the
button in long enough will cause the pilot to go out when the button is released. If the pilot goes
out when the button is released, wait at least 5 minutes then repeat this step.
PLACING THE FRYER INTO OPERATION
CAUTION
If this is the first time the fryer is being used after installation, refer to Section 3.2,
Boiling-Out the Frypot. (non-KFC co-branded locations)
For units equipped with Thermostat Controls (non-KFC co-branded locations)
Place the Melt Cycle switch (if so equipped) to the ON position. Set the thermostat knob to the
desired cooking temperature. The U-shaped burner should "light-off" and burn with a strong,
blue flame.
CAUTION
Thermostat-controlled fryers equipped with Melt Cycle switches will stay in the Melt
Cycle mode until the Melt Cycle switch is placed in the OFF position.
OFF Button PILOT Button