Fujitsu Siemens Computers E-6555 - Manual (Page 39)

39
EXIT MENU – LEAVING THE SETUP UTILITY
The Exit Menu is used to leave the setup utility. Follow
the instructions for Navigating Through the Setup
Utility to make any changes. (See Navigating Through
The Setup Utility on page 2 for more information.) The following table shows the names of the menu fields
for the Exit menu, the default settings and a description
of the field’s function and any special information
needed to help understand the field’s use.
Figure 22. Exit Menu
Table 22: Fields, Options and Defaults for the Exit Menu
Menu Field Options Default Description
Exit Saving
Changes –— –— Exit Saving Changes and Exit will store all the entries on every
menu of the setup utility to the BIOS memory and then exit the
setup utility. A confirmation message
Save Configuration
changes and exit now? [Yes] [No] will be displayed.
Exit Discarding
Changes –— –— Selecting Exit Discarding Changes and Exit will exit the setup
utility with out writing to the BIOS memory. When the BIOS
recognizes this selection it will load the operating system and
begin operation.
Load Setup
Defaults –— –— Selecting Load Setup Defaults will load the factory preset default
values for all menu fields, then display the message
Load
default configuration now? [Yes] [No]. When con-
firmed the setup utility will return to the Exit Menu. To return to
another menu follow the directions in the Navigating Through the
Setup Utility Section.
PhoenixBIOS Setup Utility
F1 Help
ESC Exit
Select Item
Select Menu -/Space Change Values
Enter Select Sub-Menu
F9 Setup Defaults
F10 Save and Exit
Main Advanced Security Power Savings Boot Exit
Item Specific Help
Exit System Setup and
save your changes to
CMOS.
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
▲