Friedrich X Star EQ08 - Manual (Page 6)

Money Fan
Set Hr. Stop Start
Temperature
Fan
Cool
On/Off
Cooler Warmer
Only Speed Saver ®
Power
Timer Operation
4
To set the timer
NOTE: You can set the START and STOP times a minimum of one hour
apart, and a maximum of 23 hours apart.
9 TIMER START - Press to view the current start time for cooling. Start
Continue pressing the Start button until you arrive at the start time
you desire. The start time for cooling will then be set.
10 TIMER STOP - Press the Stop button. Continue pressing the Stop
button until you arrive at the stop time you desire. The stop time for
cooling will then be set.
11 TIMER ON / OFF - Press the On/Off button to activate (light on) or
deactivate (light off) the timer. Once the on and off times have been
selected, they will remain in memory and cycle daily until changed.
NOTE: If the unit is unplugged or the power is interrupted, the Set Hr.
function must be reset or the On/Off function will not work.
How to use the remote control
To start unit
1 POWER - Press the Power button once. The unit will automatically
start in the mode and fan speed it was last left on.
To set mode of operation
2 COOL - Press the Cool button to automatically switch the operating
mode to COOL.
3 FAN ONLY - Press the Fan Only button if you want to run the fan
only.
4 MoneySaver ® - Press the MoneySaver ® button to activate the
MoneySaver ® feature. This feature cycles the fan with the compres-
sor so that the fan does not run all the time.
To adjust temperature setting
5 WARMER - Press the Warmer button to raise the temperature
setting.
6 COOLER - Press the Cooler button to lower the temperature
setting.
To adjust fan speed
7 FAN SPEED - Press the Fan Speed button to see the current set-
ting. Press again to change the fan speed. F1 is the lowest setting
(SLEEP / LOW), F2 is MEDIUM, F3 is HIGH, and SF is the SMART
FAN setting.
To set the hour clock
8 SET HOUR CLOCK - Press Set Hr. once to see the current clock
setting. Continue pressing the button until you arrive at the current
time (Hour only). Minutes are not shown on the display. Make sure
that the A.M. / P.M. setting is correct.
8
10
7
11
9
4 3
1 2
5 6
Figure 4
How to operate your Friedrich room air conditioner
(EQ08 model)
Function control
The left knob is a six position control that allows you to select heat or cool in
either low speed or high speed. Plus you can select fan only if you wish.
Temperature control
o c , r e l o o c r o f e s i w k c o l c
r a w r o f e s i w k c o l c
Figure 5
Additional RC1 wireless remote controls can be purchased from your Friedrich dealer.