Friedrich X Star EQ08 - Manual (Page 11)

9
STEP 7 Cut two pieces of standard 1" lumber (supplied by installer) to the
length and width required. Place in front and back of bottom sill chan-
nel as shown in Figure G. Secure with nails (supplied by installer).
STEP 8 Seal all holes in the cabinet with caulking compound (supplied
by installer).
MORTAR
ELECTRICAL RECEPTACLE
POINT "X"
CABINET
CAULK ALL SIDES
Figure H
SOLID MASONRY CONSTRUCTION
NOTE: ELECTRICAL RECEPTACLE LOCATION
FROM POINT "X" MUST BE WITHIN A MAXIMUM
RADIUS OF 69" FOR 115V UNITS.
STEP 9 Complete the installation by following STEPS 6 through 10 of Sash
Window Instructions (Page 8). Window Seal Gasket mentioned
in STEP 8 will not be required.
IMPORTANT: Before operating your unit, read STEP 10 of Sash
Window Instructions.