FUJITSU PDS4207W-H - Manual (Page 40)

40
PERSONAL COMPUTERS THAT CAN BE CONNECTED
The Plasmavision is set at the factory with adjustment values for 11 types for the RGB 1 mode and 8 types for the RGB
2 mode of signals. (See the table below.) When any of these signals is input, it is automatically discriminated. For these
signals, the desired screen can be adjusted according to the instructions on adjusting the screen.
The Plasmavision can also store settings for those set at the factory, as shown in the table below. Input the signals
whose settings are to be stored into memory and adjust for the desired screen following the instructions on adjusting the
screen. Release the adjustment button to automatically store the level into memory. After adjustment, when the same
signals are input, they are displayed with the setting levels last stored into memory.
Factory-set signals
RGB Mode Display Horizontal Vertical frequency
Supported signal
MODE number (dots
×
lines) frequency (kHz) (Hz)
1 852
×
480 31.72 59.97
Note1 When dedicated
graphics board used
2 640
×
480 31.47 59.94 VGA
3 640
×
480 37.86 72.81 VGA 72 Hz
4 640
×
480 37.50 75.00 VGA 75 Hz
5 720
×
400 31.47 70.09 VGA 400 lines
RGB 1 6
640
×
480 34.97 66.61 MAC 13RGB (1)
640
×
480 35.00 66.67 MAC 13RGB (2)
7 640
×
400 24.83 56.42 PC98 24kHz
8 640
×
400 31.50 70.15 PC98 31kHz
9 800
×
600 35.16 56.25 SVGA 56 Hz Note2
10 640
×
480 15.73 59.94 60 fields
11 640
×
480 15.63 50.00 50 fields
12 to 16 15.63 to 60.00 50.00 to 75.00 User settings
1 852
×
480 31.72 59.97
Note1 When dedicated
graphics board used
2 640
×
480 31.47 59.94 VGA
3 640
×
480 37.86 72.81 VGA 72 Hz
4 800
×
600 35.16 56.25 S-VGA 56 Hz Note2
RGB 2 5 800
×
600 37.88 60.32 S-VGA 60 Hz Note2
6 800
×
600 48.08 72.19 S-VGA 72 Hz Note2
7 1024
×
768 48.36 60.00 XGA 60 Hz Note2
8 1024
×
768 56.48 70.08 XGA 70 Hz Note2
9 to 16 31.00 to 100.0 50.00 to 120.0 User setting Note3
Note 1: The dedicated graphics board is an optional product.
2: The 800 x 600 mode and the 1024 x 768 mode are compressed display through compression interpolation. Also, the
screen display is also compressed for display.
3: Images on the screen may be blurred or not be displayed due to the settings of personal computer. Adjust or change the
resolution (frequency) of the personal computer.
Points about usage
The company names and product names in this document are trademarks or registered trademarks of their respective com-
panies.
The mode numbers indicate the SIGNAL INFORMATION modes set for the RGB 1 mode, RGB 2 mode and input source.