FUJITSU PG-FCS102 - Manual (Page 16)

116
2.1 Installing in a Server Blade
` To connect a 1Gbit/s Ethernet I/O Module to the external LAN (device), it is necessary to
install a Switch Blade or GbE Pass-Thru Blade to network blade slot 3 or network blade slot
4 (NET3 or NET4) of the chassis.
2.1.1 Installation Position of the 1Gbit/s Ethernet I/O
Module
Install the 1Gbit/s Ethernet I/O Module in the expansion board slot in the BX620 S3/BX620 S4
Server Blade.
2.1.2 Installation Procedure for the 1Gbit/s Ethernet I/O
Module
1 Turn off the server blade where the 1Gbit/s Ethernet I/O Module
will be installed.
→
"3.3 Turning Off the Server " in "Blade Server System Unit Hardware Guide"
2 Touch a metal part of the chassis to discharge static electricity
from your body.
3 Remove the server blade from the chassis.
→
"4.2 Installing Server Blades" in "Blade Server System Unit Hardware Guide"
Expansion board slot