FujiFilm 1400 Zoom - Manual (Page 34)

67
5
66
ADJUSTING THE LCD MONITOR BRIGHTNESS
If you hold down the “DISP” button for about 2
seconds, the brightness adjustment screen
appears.
➀ Use the “ d ” and “ c ” buttons to adjust the
brightness.
➁ Press the “MENU/EXE” button.
1
● ! When the LCD monitor is switched off and no text is
displayed in Photography mode (
➡ P.27, 41), the
setting cannot be changed.
● ! To exit this procedure without changing the settings,
press the “CANCEL / BACK” button.
FRAME NO. MEMORY
2
You can check the file number by viewing the
image. The last 4 digits of the 7-digit number
displayed in the top-right corner of the screen
show the file number. The first 3 digits show the
directory number.
● ! When replacing the SmartMedia, always switch the
camera off before you open the slot cover. If you
open the slot cover while the camera is still switched
on, the FRAME NO. (frame number memory)
function will not operate.
● ! File numbers run from 0001 to 9999. Once 9999 is
exceeded, the directory number goes up by 1. The
maximum number is 999-9999.
● ! If you take a picture with FRAME NO. (frame number
memory) set to RENEW, the stored “Last file No.”
setting is reset.
● ! The frame number display for images shot on other
cameras may differ.
✽ Formatted SmartMedia used for both A and B.
RENEW : Pictures are stored on each
SmartMedia beginning with a file
number “0001”.
CONT : Pictures are stored beginning from
the highest file number stored on the
last SmartMedia used.
Setting this function to “CONT” makes file
management easier as it ensures that file names
are not duplicated when images are downloaded to
a PC.
● ! If the SmartMedia already contains image files with
file numbers higher than the highest file number on
the last SmartMedia, images are stored beginning
from the highest file number on the current
SmartMedia.
➀ ➁