Furuno FS-2570 - Manual (Page 40)

3-6
3.3.4 System setting of RT
Set the RT similarly with DSC. Do the setting at System setup menu at the transceiver unit.
Item Description Setting
REGULATION Select the national regulation to change the
frequency, user channel, etc. INTL, (RUSSIA)
TX FREQ Select the frequency to transmit.
FREE: Any frequency can be set.
MARINE/USER: Can use the frequency and
radio type set in the marine band and the user
channel.
ITU/USER: Can use the frequency and radio
type set in the user channel or permitted with
ITU channel.
USER: Can use the frequency and radio type
set in the user channel. FREE, MARINE/USER,
ITU/USER, USER
AM ENABLE Select the method of AM (H3E). OFF: TX/RX are
not available. TRX: TX/RX are available. RX: RX
only is available. OFF, TRX, RX
LSB ENABLE Select ON to transceiver/receive LSB. OFF, ON
TX TUNE Turn the tuning of the antenna coupler on/off. OFF, ON
COUPLER
THROU
(through) Selects the route on receiving.
(OFF: Runs via antenna coupler.) OFF, RCVD, DUPLEX
NMEA Choose the acceptable NMEA version. V3.0, COMPATIBLE
TONE For maintenance.
TX MODE Select the radio band to set the
TX power. SSB/CW, TLX
TX FREQ (CH) Select the frequency to set. 2182.0 kHz
TX POWER Select the output level to set
TX power. HIGH, MID, LOW1, LOW2,
TUNE
TX POWER ADJ Set the TX power. 0-255, 0
TX TONE Transmit TONE. OFF, ON
TX POWER
(FREQ)
TX POWEER
(USER CH)
LOAD DEFAULT Restore TX settings to default. YES, NO
50 Ohm BK Selects the installation situation of the 50 ohms
BK. ENABLE, DISABLE
CW ENABLE Enable/disable the CW. OFF, ON
Bold: default setting