Furuno FS-2570 - Manual (Page 3)

i
SAFETY INSTRUCTIONS
Confirm that the power supply voltage
is compatible with the voltage rating
of the equipment.
Connection to the wrong power supply
can cause fire or equipment damage to the
equipment . The voltage rating appears on
the label at the rear of the display unit.
CAUTION
WARNING
Do not work inside the
equipment unless totally
familiar with electrical
circuits.
Hazardous voltage which can
shock exists inside the equip-
ment.
Turn off the power at the
mains switchboard before
beginning the installation.
Post a sign near the switch
to indicate it should not be
turned on while the equip-
ment is being installed.
Fire, electrical shock or
serious injury can result if the
power is left on or is applied
while the equipment is being
installed.
Standard Steering
compass compass
Keep the following compass safe
distances.
Ground the equipment.
Ungrounded equipment can
give off or receive electro-
magnetic interferenece or
cause electrical shock.
Transceiver
Unit
FS-1570T
FS-2570T
FS-2571C
HS-2003
AT-1560-15
AT-1560-25
PP-510
IC-302/303
SEM-21Q
PR-850A
PR-300
IB-581
IB-583
1.20 m 0.70 m
2.20 m 1.40 m
0.90 m 0.60 m
1.50 m 0.95 m
1.00 m 0.70 m
1.00 m 0.80 m
0.80 m 0.60 m
2.20 m 1.50 m
1.00 m 0.70 m
0.90 m 0.70 m
1.40 m 1.00 m
0.70 m 0.40 m
DANGER
Do not touch cable from
the antenna coupler during
transmission.
Electrical shock, serious
injury or death can result if
the cables are touched during
transmission.
Do not touch the whip
antenna or wire antenna.
Electrical shock, serious
injury or death can result if
the antenna is touched during
transmission.
DANGER
Do not touch this point.
Use copper strap with careful.
An edge of it may harm your hand.