FUJITSU FI-5530C2 - Manual (Page 23)

fi-5530C Image Scanner Getting Started
AP-2
Paper is not fed (pick error
occurs frequently, or docu-
ment stops midway).
Do the documents satisfy the "Docu-
ment Quality" and the "Multi feed
Detection Conditions" in the chapter 6
of "fi-5530C2 Operator’s Guide"?
Use the documents that satisfy the "Document
Quality" and the "Multi feed Detection Condi-
tions" in the chapter 6 of "fi-5530C2 Operator’s
Guide."
Is the Pick roller dirty? Clean the Pick roller. For details, refer to section
3.2 "Cleaning the ADF"of "fi-5530C2 Operator's
Guide."
Is the Pick roller worn out? Clean the Pick roller. For details, refer to section
4.3 "Replacing the Pick Roller" of "fi-5530C2
Operator's Guide."
Is there any debris on the document feed
path?
Remove any debris from the document feed path.
The generated images are
elongated.
Are the Feed rollers dirty? Clean the Feed rollers. For details, refer to section
3.2 "Cleaning the ADF"of "fi-5530C2 Operator's
Guide."
Have you adjusted the scan magnifica-
tion?
Select "Scanners and Cameras" in the control
panel, then click the [Device Set] tab to adjust
magnification.
There is a shadow on the
leading edge of the gener-
ated image?
Are the Feed rollers dirty? Clean the Feed rollers. For details, refer to section
3.2 "Cleaning the ADF"of "fi-5530C2 Operator's
Guide."
Have you adjusted the offset (the scan-
ning starting position)?
Adjust the [Sub-scan Setting] on [Scanners and
Cameras] in the control panel.
Symptom Check this item Remedy