FUJITSU MAB3045 - Manual (Page 84)

C141-E035-02EN 5 - 5
5.3 Setting Terminals
The user must set the following terminals and SCSI terminating resistor before installing the
IDD in the system.
•
Setting terminal: CN6, CN7
Figures 5.2 shows the setting terminal position of SP model. Figures 5.3 shows SP models for
allocation and default settings.
CAUTION
1. The user must not change the setting of terminals not described in this
section. Do not change setting status set at factory shipment.
2. Do not change the setting of terminals except following setting pins
during the power is turned on.
•
Write protect
MAx3xxxSP: CN7 13-14
3. To short the setting terminal, use the short plug attached when the
device is shipped from the factory.
Figure 5.2 MAx3xxxSP setting terminals position
1
6
CN7
1/2
15/16
CN6
CN1