FUJITSU MAB3045 - Manual (Page 66)

C141-E035-02EN 4 - 15
(2) SCSI connector and power supply connector
a. 16-bit SCSI
The connector for the SCSI bus is an unshielded P connector conforming to SCSI-3 type
which has two 34-pin rows spaced 1.27 mm (0.05 inch) apart. Figure 4.17 shows the SCSI
connector. See Section C3 in Appendix C for the signal assignments on the SCSI
connector.
For details on the physical/electrical requirements of the interface signals, refer to Sections
1.3 and 1.4 in the SCSI Physical Interface Specifications.
Figure 4.17 16-bit SCSI interface connector
b. Power supply connector
Figure 4.18 shows the shape and the terminal arrangement of the output connector of DC
power supply.
The tolerance is ±0.127 mm (0.005 inch) unless otherwise