Fisher-Price 78475 - Manual (Page 9)

Assembly
F
1
• Fit the cover plate over the opening above the louvers in
the front of the vehicle body.
• Insert two # 8 x 1 /
2
" screws through the cover plate and
into the vehicle body.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Cover Plate
Vehicle
Body
• Fit a hubcap on the rear axle and slide it into the center
of the rear wheel.
• Position the vehicle body upside down. Make sure that
the tabs on the gearboxes rest against the rear axle
support bars so the gearboxes and motors do not
hang down.
• Slide two 7 /
16
" washers onto one of the rear axles.
• Slide a rear wheel, driver side first, onto the rear axle.
• Fit the teeth on the gearbox into the notches in the driver.
7 /
16
" Washers
Tabs
Rear Axle
Support Bar
Rear Wheel
Rear Axle
Gearbox
Driver
Teeth
Rear Axle
Hubcap
2
3
4
• Slide a hex bushing onto the rear axle. The ring side of
the hex bushing should face out.
• Press firmly to fit all but the ring on the end of the hex
bushing into the rear wheel.
Hex
Bushing
Rear Axle
Ring Side
9
Louvers