beautypg.com

4 messages – FUJITSU PRIMEPOWER B23Q8YA-G-02-F User Manual

Page 32

background image

26

protocol.

z Since PRIMECLUSTER GLS 4.1A20 or previous version do not correspond to a VLAN interface,

please do not use VLAN interface with those. PRIMECLUSTER GLS 4.1A30 or later (only Fast

switching mode or NIC switching mode) can use VLAN interface.

z VLAN function can be used only in Solaris 8, Solaris 9 or Solaris 10.
z In the environment where PRIMECLUSTER has been installed, in case you use a VLAN interface,

please check that the "SMAWdtcp" package has not been installed. When installed, please remove

that package or do not use a VLAN interface.

z A VLAN interface uses about 700Kbyte at MTU size 1514byte or 900Kbyte at MTU size 9014byte of

memory (at the time of no communicating). Therefore, when creating two or more VLAN interfaces

and performing communication, a slowdown may occur due to the shortage of resources depending on

the system configuration.

4.4 Messages

Messages by fjgi driver are listed in the following table.

Table 4.3 Console Messages of the fjgi driver

Message Cause

Workaround

network connection down

Link down was happened.

When Link down not intended is

generated, abnormality of the

transmission line is thought. Please

confirm the specification of the cable

and the switch.

Connected

-speed

1000: Transmitting and receiving by

1000Mbps

100: Transmitting and receiving by

100Mbps

10: Transmitting and receiving by

10Mbps

-autonegotiation

on: Set in autonegotiation

off: Not setting in autonegotiation

-duplex mode

full: Transmitting and receiving by

full duplex

half: Transmitting and receiving by

half duplex

network connection up

using portA

speed:

autonegotiation:

duplex mode:

flowctrl:

( role: )*1

-flowctrl

symmetric: Doing Flowcontrol each

other

remote send: Accept Flowcontol only

from

the

other.

local send: Doing only own

Flowcontrol

none: Not doing Flowcontrol.

There is no problem.