Useful information -86, Equipment care and troubleshooting, Us e fu l in fo rm a ti o n – Hitachi P50V701 User Manual
Page 80: Symptoms
80
Equipment Care and Troubleshooting
TROUBLESHOOTING
Your HITACHI Plasma Television incorporates advanced power surge protection technology designed to protect
against component or circuit damage due to external or internal voltage power surges.
IF YOUR TELEVISION SHOULD APPEAR TO HAVE A LOSS OF POWER, PLEASE FOLLOW THIS
PROCEDURE:
1.
Press the POWER
SWITCH (ON/OFF
SWITCH) once.
2.
If there is still no power,
wait 30 seconds and
press the POWER
SWITCH again.
3.
If there is still no power,
unplug the power cord
from the wall. Wait 30
seconds and plug the
power cord back in.
Press the POWER
SWITCH again.
This protective technology
should provide for years of
lasting entertainment from
your
HITACHI
Plasma
Television.
DO
Dust the screen and cabinet with a soft cloth.
Clean the screen with a soft cloth moistened in warm
water and dry with a soft cloth. A mild soap may be
used if the screen is extremely dirty.
Place your Plasma Television away from extreme heat,
humidity, and extremely dusty places.
Remove the plug from the wall outlet if your Plasma
Television will not be used for a long period of time, for
instance, when you go on vacation.
DO NOT
Do not clean your screen with strong cleaners, polishes
or a chemically treated cloth.
Do not place rubber or vinyl products or cellophane
tape on your Plasma Television.
Avoid repeatedly touching the screen.
Do not subject the remote control to shocks such as
dropping it on the floor, etc. This may cause damage to
the precision parts.
Avoid placing the remote control in a high humidity
place or getting it wet. Do not leave it on or near a
heater. Excessive heat or moisture may cause the unit
to fail.
When the batteries run down, remote control operation
will become erratic or become unresponsive. Replace
the old batteries with two new “AA” size batteries. Do
not use an old battery with a new battery.
Exposing the screen to direct sunlight for a long period
of time or heat may cause damage to the plasma
screen.
SYMPTOMS
CHECK THESE ITEMS AND
TRY THESE ADJUSTMENTS
No Picture, no sound
Sound OK, picture poor
Picture OK, sound poor
Picture blurred
Lines or streaks in picture
Poor reception on some channels
Picture rolls vertically
No color
Poor color
© © © © © © ©
©
©
©
©
©
© © © © © © ©
© © © © ©
©
© © © © ©
© © © © ©
© © © © ©
©
©
© © © ©
© © © ©
©
© ©
Be
su
re externa
l connectio
n is
corre
ct
Be sure
p
ower cord is
plugged in
Be sure
TV is switched''ON"
Tr
y
a
nothe
r
channel (station trouble)
Chec
k
antenn
a
connections (back
of TV)
Check
anten
n
a
for brok
en lead-i
n
wire
Check for lo
cal interfe
rence
Check
outside
antenna
Adjust Contrast control
Adjust Brightn
ess
control
Adjust Color control
Adjust
T
int
co
ntrol
Adjust
V
olume
control
U
s
e
fu
l
In
fo
rm
a
ti
o
n