Hitachi P50V701 User Manual

Page 37

m
o

YOUR SET-TOP-BOX/SATELLITE RECEIVER.

This remote is designed to operate different types of
set-top-box/satellite systems. You must first program
the remote to match the remote system of your set-
top-box/satellite systems (refer to pages 41-42 for pre-
codes).

1. Turn ON your set-top-box/satellite systems.

2. To switch to set-top-box/satellite (SAT) pre-coded

mode, use the SOURCE SELECT button on the

remote control to position the LED light to the

corresponding selection SAT/CBL.

3. Hold down the SOURCE SELECT button on the

remote and enter the four digit preset code that matches

your set- top-box/satellite receiver as shown on page

41-42. Release the SOURCE SELECT button. The

indicator light will flash 3 times if the code was accepted.

4. Aim the remote at the set-top-box/satellite receiver

and press the

POWER button. The remote will turn

off your set-top-box/satellite receiver when the
correct four digit preset code is entered. When this
occurs, the remote control is programmed for your
set-top-box/satellite receiver. If the set-top-
box/satellite receiver does not turn off, try a
different four digit preset code.

5. The remote will now control your set-top-box/

satellite receiver.

NOTE: 1. If your set-top-box/satellite receiver

cannot be operated after performing the
above procedures, your set-top-box/
satellite receiver code has not been
precoded into the remote.

2. In the unlikely event that your set-top-

box/satellite receiver cannot be operated
after performing the above procedures,
please consult your set-top-box/satellite
receiver operating guide.

3. The remote control will remember the

codes you have programmed until the
batteries are removed from the
remote control. After replacing the
batteries repeat the entire programming
procedure as stated above.

ቢ PRECODED SET-TOP-BOX/SATELLITE

RECEIVER buttons
These buttons transmit the chosen pre-coded

set-top-box/satellite codes :

ባ EXCLUSIVE TV buttons

These buttons are for operating the TV

MY Satellite RECEIVER/
SET-TOP-BOX CODE IS:

NOTE: Refer to instruction manual of the Set-Top-

Box/Satellite Receiver for operation of the
buttons exclusively for the Set-Top-
Box/Satellite Receiver.

The Remote Control for Set-Top-Box/Satellite Receiver Functions

OPERATING THE PRECODED FUNCTION FOR

ቢ

ባ

ቢ

ባ

ቢ

-Power

-Menu

-Exit

-Guide

-Cursor & Select

-Info

-Channel Up & Down

-Last CH

-Number PAD

-Enter, Dash

-Inputs (Only if

-Day/Night

-Aspect

-PIP

-CC

-Vol Up & Down

-Mute

programmed,

refer

ባ

to page 40).

ባ

-Pause