Hitachi P50V701 - Manual (Page 55)

O
n
-S
c
re
e
n
D
is
p
la
y
channels.
Channel Manager
Select CHANNEL MANAGER to set your Antenna
options, run Auto Channel Scan, Check Signal Meter
and Set Channel List.
1. Press CURSOR PAD ̆,̄ to highlight functions.
2. Press the SELECT button or CURSOR PAD ̈ to
select.
Signal Meter
Select SIGNAL METER when using an indoor or outdoor
antenna. This feature will show the signal strength and
peak values of the Antenna signal to help you adjust your
antenna to optimize signal reception.
Use the CURSOR PADS and the SELECT button to
highlight and select CLOSE to exit.
NOTE: 1. The Signal Meter will not be available (grayed
out) when watching analog channels.
Auto Channel Scan
This feature will automatically store active Analog and
Digital channels in Auto Channel Scan memory.
Channel Manager
1. Use the CURSOR buttons to highlight AIR,
CABLE (1) or CABLE(2) source.
2. Press the CURSOR buttons
̇ or ̈
to highlight the
START or RESET option.
3. Press the SELECT button to select.
̇
or
̈
NOTE: 1. If certain channels are poor or not possible
in cable(1) mode, set cable source to cable(2)
by using the CURSOR buttons ̇ or ̈.
Move SEL Select
Channel List
Auto Channel Scan
Signal Meter
Channel Manager
Auto Channel Scan
Channel Manager
Move SEL Return
Source Air
Start Reset Auto Channel Scan
Move SEL Select
Channel List
Auto Channel Scan
Signal Meter
Move SEL Return
Signal Meter
Channel Manager
Channel 3 - 1
Strength 91
Peak 91
SNR 10
Close
Move SEL Select
Channel List
Auto Channel Scan
Signal Meter
Channel Manager
55
Channel Manager
OR
OR
OR
TV Guide On Screen
Move SEL Select
Setup
Timers
Channel Manager
Locks
Audio
Video
Power Swivel
OOB Lock/Unlock Lock
OOB SNR 60 dB
OOB Frequency 105 MHz
Also this feature will show you the status of the Out
Of Band (OOB) channel, if locked or unlocked as
monitoring the noise rejection and the frequency values
of the OOB channel.
2. The OOB options work only for CableCARD