Henny Penny SCR-6/8 - Manual (Page 41)

SCR-6/8
6-2. ERROR CODES
DISPLAY CAUSE PANEL BOARD CORRECTION
“E-4” “Prob Err” • Control board too hot; • Clean or have blower replaced
blower wheel clogged
or not working
“E-6” “ctrl hot” • Temperature probe • Check probe connection at board, or
failure have probe replaced
“E-50” “CPU Chip” • CPU RAM Error • “E-50”, “E-51”, “E-53”, and “E-41”
are software errors; reinitialize the
“E-51” “rA-CHIP” •External RAM error board, and if error persists, replace
control board
“E-53” “ro-CHIP” • External ROM error
“E-41” “data Err” • Scrambled Memory
“E-5” “too hot” • Software high limit • Have control board and contactor
(Air Temperature too hot) checked or replaced
• Have blower checked and replaced if
necessary
203 6-2