Step 5 - wiring the fan – Hunter Fan Hunter Ceiling Fans 41462-01 User Manual

Page 12

41462-01 10/14/2005

CONNECTING FAN TO ELECTRI-

CONNECTING FAN TO ELECTRI-
CAL SOURCE

CAL SOURCE

1. Connect the wires as shown in

Figure 5. To connect the wires,
twist the bare metal leads to-
gether. Place a wire nut over the
intertwined length of wire and
twist clockwise until tight as
shown.

2. Separate the connected wires by

placing the green and white wires
on one side of the outlet box and
the black wires on the other side
of the outlet box.

CAUTION

Be sure no bare wire or wire
strands are visible after mak-
ing connections.

STEP 5 - WIRING THE FAN

WARNING

ARNING

• To avoid possible electrical

shock, before wiring fan,
disconnect power by turn-
ing off the circuit breakers
both to the outlet box and
to its associated wall switch
location. If you cannot lock
the circuit breakers in the
off position, securely fasten
a prominent warning de-
vice, such as a tag, to the
service panel.

• All wiring must be in accor-

dance with national and lo-
cal electrical codes and
ANSI/NFPA 70. If you are
unfamiliar with wiring, you
should use a qualified elec-
trician.

WARNING

ARNING

To reduce the risk of fire, elec-
trical shock, or motor damage,
do not lift or carry the fan by
the lead wires.

3. Turn the connectors upward. Push

the wires gently into the outlet
box.