HP RM-20 - Manual (Page 20)

SmartShare
®
User Manual
– 19 –
LED Indicators
The two LEDs for each LAN/WAN/Ext1/Ext2 Ethernet port indicate as follows:
LINK/ACT = Off
No connection.
LINK/ACT = On, 10/100 = Off 10Mbit link to other device established.
LINK/ACT = On, 10/100 = On 100Mbit link to other device established.
LINK/ACT = Blink Link is active with transmissions.
The POWER LED indicates as follows:
POWER = Off
Power is off.
POWER = Orange Light Power is on.
The STATUS LED indicates as follows:
STATUS = Green Light
The SmartShare is booting.
STATUS = Green Blink Slow Data connection to ISP is established.
Download Limiter is ready.
STATUS = Green Blink Fast Data connection to ISP is established.
Download Limiter is active.
STATUS = Red Blink Slow Connection to ISP is down or not established yet.
STATUS = Red Blink Fast (Not used.)
STATUS = Red Light Internal System Error.
STATUS = Red and Green Internal System Error.
Glossary
ATL Anti Terror Logger (or Anti Terror Logging)
DHCP Dynamic Host Configuration Protocol
DNS Domain Name System
DSCP Differentiated Services Code Point
FTP File Transfer Protocol
IP Internet Protocol
ISP Internet Service Provider
LAN Local Area Network
LED Light Emitting Diode
MTU Maximum Transmission Unit
NAT Network Address Translation
NAPT Network Address and Port Translation
NTP Network Time Protocol
QOS Quality Of Service
SMTP Simple Mail Transfer Protocol
SNMP Simple Network Management Protocol
SPI Stateful Packet Inspection
TOS Type Of Service
WAN Wide Area Network