Huawei ADSL2+Broadband Router Aolynk DR814 - Manual (Page 40)

User Manual
Aolynk DR811/DR814 ADSL2+Broadband Router
4 Web-based Management
37
Figure 4-28 ZIPB setting
This page allows you to:
l Enable/disable the ZIPB mode.
l Perform advanced ZIPB configurations.
If the ZIPB is currently disabled, you may click the button to enable it. If the
ZIPB is currently enabled, you may click the button to disable it.
To select which of your LAN computers will use the public IP address, click on the
drop-down list below Choose which computer will use the public IP address,
position the cursor over the entry and left-click to select a LAN computer, and then click
the button.
To perform advanced ZIPB configurations, proceed according to the following steps:
l Select the LAN interface that ZIPB will run on: click on the LAN interface drop
down list and select an interface.
l Select the WAN interface that ZIPB will run on: click on the WAN interface drop
down list and select an interface.
Once you have configured ZIPB, click the button.
& Note:
Make ensure that ZIPB is disabled before you configure ZIPB. Edit the configurations
and click OK, the new configuration will take effect after you enable ZIPB.
Configuration changes on ZIPB will not be kept permanently, so you need to configure
it again whenever the Router is restarted. In this way, remember to renew the IP
address of the ZIPB host first.