Hand Held Products Dolphin 7200 - Manual (Page 67)

Dolphin® 7200 User’s Guide 9 - 5
Charging a Dolphin Terminal
The HomeBase supplies charging power to the Dolphin terminal so that the terminal can monitor the charging of its battery pack.
This charging method protects the battery from being damaged by overcharging. Therefore, the Dolphin terminal may be stored
indefinitely in the HomeBase without damage to the terminal, the battery pack, or the HomeBase.
1. Insert a battery pack into the Dolphin terminal.
2. Place the terminal, laser engine window up and the LCD visible, in the Dolphin Terminal Well of the Dolphin HomeBase.
3. Let it glide down into the well until it stops.
4. Once the Dolphin terminal is properly seated, the Dock LED on the HomeBase will be solid green.
Deep-Cycling Batteries
For maximum battery life, Hand Held Products recommends that you deep- cycle (service) the battery twice before initial use and
then, once a month thereafter. Since the Dolphin 7200 Compact HomeBase does not have deep-cycling capabilities, it is
recommended that you use the Dolphin 7200 Multicharger or the Dolphin 7200 HomeBase.
The deep-cycling process using the Multicharger takes approximately 9.5 hours. For more information, see the Dolphin 7200
Multicharger User's Guide.
Mounting the Dolphin 7200 Compact HomeBase
The Dolphin 7200 Compact HomeBase may be desk or wall-mounted for convenience and storage.
Desk Mounting:
The Compact HomeBase has a DIN rail (7.5 X 35 mm) slot on the bottom to allow for secure desk attachment of the unit if desired.