AAXA Technologies P7+ 550-Lumen Full HD LED SmPico Projector - Manual (Page 7)

Getting Started
4
Chapter 2
1. Connect the power cord to the P7+.
2. Connect the other end of the power cord into the wall power source.
3. Toggle the On / Off switch on the side of the projector to the “ON” position - the
projector should automatically turn on.
Powering ON the projector
Powering OFF the projector
Standby Mode
1. To transition to “STANDBY” mode, press the power button on the remote control.
2. The optical engine should power off and the fan should stop spinning. The projector
is now in “STANDBY” mode and can be turned on using the remote control.
*Note: Standby mode will still consume a small amount of power.
1. To turn off the projector, toggle the
“Power Switch” to the “OFF” position.
This will fully turn off the projector. The
unit can only charge when it is off.