AAXA Technologies P7+ 550-Lumen Full HD LED SmPico Projector - Manual (Page 44)

41
Technical Details
IMAGE IS BLURRED
Possible Causes Solution
The Projector is not in focus. Adjust the focus with the focus adjustment but-
tons on the remote control until the image comes
into focus, or use the focus adjustment buttons on
the side of the projector
The Projector is offset from plane / angle of opera -
tion.
Move the projector so that it is both 180 degrees
and on an evern plane with the screen or adjust
the keystone through the remote, keypad or Set-
tings Menu
NO SYNC, NO SIGNAL
Troubleshooting
Be sure to setup the computer to enable a video signal output. On some laptops this is
done by pressing and holding Function F5 key. If using the P7+ as an external monitor on
Windows based systems, this can be done by selecting “extend my desktop to this moni-
tor”. Depending on the video driver different resolutions may need to be selected for proper
output.