AAXA Technologies P7+ 550-Lumen Full HD LED SmPico Projector - Manual (Page 46)

43
Technical Details
Projector not charging
Possible Causes Solution
There is no power. Check to ensure the power outlet source is good.
Check the power adapter to ensure a proper con-
nection with the wall outlet as well as the projector.
The projector is not set to the “OFF” Mode. Connect the power cord to the P7+. Connect the
other end of the power cord into the wall power
source. Toggle the “On/ Off” switch to the “OFF”
Position.
When the projector is fully charged, the LED light
on the side of the projector will turn green. Allow
approximately 3-4 hours to fully charge the the
projector.
Troubleshooting