Vox Adio Air GT 2x3" 50W Bluetooth Guitar Amplifier - Manual (Page 12)

12
Auto power-off function
The amp has an auto power-off function. With this func-
tion, the amp automatically turns off if there is no opera-
tion for approximately 1 hour with no input from the
INPUT jack. When the amp turns off, even operating a
knob or button does not turn the amp back on.
When the input level is extremely low or there is very little
change in the sound, the auto power-off function may be
activated. In addition, depending on the settings and
environment, the amp may interpret noise as input, even if
the guitar is not being played.
The auto power-off function will not operate while the
amp is connected to another device via USB or Bluetooth.
Tip As the factory default setting, the auto power-off function
is enabled.
Enabling/disabling the auto power-off function
1. While holding down the TAP button, turn on the amp.
The TAP/TUNER LEDs indicate the current setting.
enabled disabled
2. Press the TAP button to switch between enabling and
disabling the function.
3. Wait without performing any operation for a few
seconds. The setting is applied, and the amp automati-
cally returns to normal operation.
Selecting a program
User program mode
The mode where you can select a program is called user
program mode.
Tip As the factory default, previously specified sounds are saved. By using
the various knobs, you can adjust the selected sound as desired.
Selecting a program in the same bank
Press the USER PROGRAMS button.
Selecting a program in a different bank
Press the BANK/MANUAL button. The BANK LED
changes color and blinks. Press the USER PROGRAMS
button.
Tip Pressing the BANK/MANUAL button again stops the
blinking of the LED and returns to the previous bank.
Manual mode
When the BANK/MANUAL button is held down
for at least 1 second, the BANK LED turns off, and
the amp enters manual mode, where the actual
setting positions of all knobs are applied directly to
the sound.
In manual mode, all knobs are operated as on a
conventional guitar amp, enabling you to create
your own sound.
Saving a program
After adjusting the various knobs and buttons to
create your desired sound, it can be saved as a user
program.
Tip When saving programs within the same bank, start
the procedure from step 2.
Programs are saved by overwriting. In other
words, a program selected in step 2 will be erased.
1. To save a program to a different bank or while
in manual mode, press the BANK/MANUAL
button to select the bank where the program
will be saved. (BANK LED blinks)
Tip To cancel the save operation, press the
TAP button. The BANK LED stops
blinking, and the amp returns to its
previous mode.
Tip In user program mode, pressing the
BANK/MANUAL button again returns to
the previous bank, and the LED stops
blinking.
2. Hold down the USER PROGRAMS button of
the save location until the LED changes from
blinking to lit (at least 2 seconds). The program
is saved to the selected location, and the bank
and program for the save location are selected.
If you switch to another program or
manual mode or turn off the amp before
saving the sound that you are creating, the
changes that you made will be lost.