Vox Adio Air GT 2x3" 50W Bluetooth Guitar Amplifier - Manual (Page 11)

11
The wide function does not affect the output from the
PHONES jack or USB port.
l. [ Adio Air GT only ] BLUETOOTH button, (Bluetooth
MIDI) LED and (Bluetooth audio) LED
Use when connecting other devices via Bluetooth ( →
“Using as wireless speakers (Bluetooth audio)” and
“Using Tone Room via a wireless connection (Bluetooth
MIDI)”).
m. PHONES(Headphones) jack
Use this jack if you want to output directly to a mixer or
recording device, or when you want to use headphones.
When a device is connected to this jack, no sound will be
output from the internal speaker.
Be sure to connect a stereo plug to this jack.
Rear panel
c b a
a. AUX IN jack
Connect the analog output of an audio device to this jack.
You can connect an audio player to this jack, then play
along on your guitar while listening to your favorite songs.
b. USB port
Use a commercially available USB cable to connect a
computer or other USB-equipped device to this port.
c. DC 19V jack
Connect the included AC adapter here.
The AC adapter is designed specifically for the
Adio Air GT/Adio GT. Do not use any other adapter,
otherwise a malfunction may occur.
Setup
Installing the batteries
Remove the battery cover from the rear of the cabinet.
Insert eight AA batteries, either alkaline or nickel-metal
hydride, taking care that each battery is correctly oriented
according to the polarity as shown in the illustration.
Batteries are not included. You must purchase them
separately.
Make sure that each battery is correctly oriented according
to the polarity.
Do not mix partially used batteries with new ones, and do
not mix batteries of differing types.
Replacing the batteries
Replace the batteries when the power LED becomes dim.
As the batteries run low, the volume may become insuf-
ficient, or you may hear noise in the sound.
Depleted batteries should be removed immediately. If
depleted batteries are left installed in the unit, they may
leak, causing malfunctions. You should also remove the
batteries if you don’t plan to use the unit for an extended
length of time.
Connecting the AC adapter
1. Connect the power cord to the included AC adapter.
2. Insert the plug of the AC adapter into the DC 19V jack on
the amp.
3. Insert the plug of the power cord into an AC outlet.
Only use the specified AC adapter. Using any
other AC adapter may cause malfunctions.
In order to prevent electric shock or damage to
equipment, securely connect the ground.
Turning on the power
1. Turn the INSTRUMENTS and AUDIO knobs on the
amp counterclockwise to their minimum settings.
2. Plug the cable connected to your guitar into the
INPUT jack. If an audio player will be used, connect it
to the AUX IN jack.
3. Hold down the (Power) button until the Power
LED lights up and the amp turns on.
Tip To turn off the amp, hold down the (Power)
button until the Power LED turns off.
4. Slowly turn the INSTRUMENTS and AUDIO knobs to
adjust the volume.