Godox TT600 Thinklite Flash - Manual (Page 9)

- 26 -
Using the Flash
Attach the Camera Flash.
● Slip the camera flash’s
mounting foot into the camera’s
hotshoe all the way.
Secure the Camera Flash.
● Rotate the locking screw on
the mounting foot until it locks
up.
Detach the Camera Flash.
● Rotate the locking screw
on the mounting foot until it is
loosened.
1.Power Management
Use ON/OFF Power Switch to power the flash unit on or off. Turn
off if it will not be used for an extended period of time. This flash
unit has Sleep Function and will enter into sleep status when there
is no operation for a long time. For Sleep Function setting, see the
following instruction.
2.Flash Output
● Flash output can be varied from 1/128th power to 1/1 full power
in 1/3 stop increments. To obtain a correct flash exposure, use
a hand-held flash meter to determine the required flash output.
● Adjust the power output by rotating Select Dial . The following
table makes it easier to see how the stop changes in terms off/
stop when you increase or decrease the flash output:
3. ZOOM: Setting the Flash Coverage
The flash coverage can be set to match the lens focal length from
24 mm to 200 mm. Press <
> button and rotate Select Dial
< > to change the flash coverage.
Attaching to a Camera
Figures displayed when reducing flash output level
Figures displayed when increasing flash output level
When setting the flash coverage, make sure it covers the lens
focal length so that the picture will not have a dark periphery.
When “OF” is shown on the LCD display, it means no flash
output and flash firing is turned off.
1
2
3
1/1
1/1-0.3 1/1-0.7
1/2
1/2-0.3 1/2-0.7
1/4
...
OF
1/2+0.7 1/2+0.3 1/4+0.7 1/4+0.3 ...