Godox TT600 Thinklite Flash - Manual (Page 10)

- 27 -
Using the Flash
4. M Mode: Manual Mode
Press MODE Selection Button < > to enter M mode. In this
mode, you can set the flash unit onto your camera hot shoe or your
trigger hot shoe for firing. Before shooting, adjust the flash power
output. When the camera’s shutter is pressed, the flash will fire
synchronously. Slave triggering mode is not available in M mode.
5. Multi Mode: Stroboscopic Flash
Press Mode Selection Button < > to enter Multi mode
(Stroboscopic flash). With stroboscopic flash, a rapid series of
flashes is fired. It can be used to capture multiple images of a
moving subject in a single photograph. You can set the firing
frequency (number of flashes per sec. expressed as Hz), the
number of flashes, and the flash output. For setting procedures,
see the following:
Calculating the Shutter Speed
During stroboscopic flash, the shutter remains open until the firing
stops. Use the provided formula to calculate the shutter speed
required to capture the full sequence of flashes:
Number of flashes / Firing frequency = Shutter speed
For example, if the number of flashes is 10 and the firing frequency
is 5 Hz, the shutter speed should be at least 2 sec.
Note:
● Stroboscopic flash is most effective with a highly reflective
subject against a dark background.
● Using a tripod and a remote switch is recommended.
● A flash output of 1/1 or 1/2 cannot be set for stroboscopic
flash.
● Stroboscopic flash can be used with “buLb”.
Press the Mode Selection
Button <
> so that “Multi” is
displayed.
Press Set Button < > to
select the item to be set. The
item blinks.
Rotate Select Dial < > to
set a desired number.
1
2
3