Bolt VB-22 Bare-Bulb Flash - Manual (Page 28)

28 | Troubleshooting
Troubleshooting
Problem Solution
The flash is stuck in a hot shoe. • Turn the hot shoe mount locking ring counterclockwise until loose.
The flash is turned on but won’t
fire. • Check that the flash is connected to a power source, the power
source is turned on, and the cables properly connected.
(Page 14)
• If connected via hot shoe, make sure the pin at the bottom, as well
as the hot shoe, are clean and free of debris.
• If the flash has overheated, it will need 10 to 15 minutes to cool
down before being able to fire again. (Page 18)
• The power setting is set to “OF”. (Page 18)