Bolt VB-22 Bare-Bulb Flash - Manual (Page 22)

22 | Repeat Mode
Repeat Mode
Repeat Mode, sometimes referred to as Stroboscopic Mode, causes the unit to fire multiple flashes rapidly.
This allows the camera to capture multiple images of a moving subject in a single exposure.
To use Repeat Mode:
• Press the Mode Selection button until “RPT” is displayed on the LCD screen.
• Press the Set button until the Times indicator flashes, then use the Selection Dial to choose your desired
amount.
• Press the Set button again to adjust the flash frequency. Use the Selection dial to find your desired setting.
• Press the Set button again to confirm your settings.
• Set your camera to the appropriate shutter speed.
• Take a test shot to confirm settings.
NOTE: To adjust your camera’s shutter speed, divide the Repeat Count number (the number of flashes per
frame) by the set frequency of the flash.