Bolt VB-22 Bare-Bulb Flash - Manual (Page 17)

Mounting the Flash | 17
Mounting the Flash on a Shoe or Stand/Tripod Mount
1. If using a VB-22, ensure that the Shoe Mounting Foot is
securely installed.
2. With the unit turned off, loosen the tightening ring on
the mount.
3. Slide the unit into the shoe.
4. Secure the flash by turning the tightening ring
clockwise.
Mounting the Flash on a Stand
1. Holding either the Stand/Tripod Mount or the VB-22
with the Stand Mounting Foot securely installed, place
the threaded socket over the stand’s ¼”-20 installation
screw.
2. Screw in the Stand/Tripod Mount or VB-22 by turning it
clockwise until tight and secure.
3. If using the Stand/Tripod Mount, follow the steps above
to mount the flash on the foot.