Moza Slypod Pro Master Kit - Manual (Page 8)

7
● Segmentation Mode
Select the segmentation mode, add a path (Click to add the path. 5 paths is the most that can
be added, tap confirm before adding the next path).Slide the S operating point and the E operating
point to any position to set the starting position and end position of the first path. Slide the E operating
point to set the end position of the second, third, fourth or fifth path. Then the starting point of the
next path will be the end position of the previous one.
Tap to start
Path
number
Tap to confirm the
path before adding
the next path.
Beginning (number
shows the distance
from the origin)
Tap to the red
area to set the
running time
S operation
point
E operation
point
End (number
shows the
distance from
the origin)
Tap to
delete
the path
Tap to reset
the path
Tap to add
the path
Tap the “Upwards” and the device will move up automatically; Tap again and the device stops
moving. Tap the “Downwards” and the device will move down automatically; Tap again and the
device stops moving. Tap ‘Take photo’, the SLYPOD PRO controls the camera to take a photo.
(SLYPOD PRO needs to be connected to the camera with the camera control cable, the camera
control cable needs to be purchased separately) Speed setting: Drag the white mark to set the
device acceleration speed, and the device will continue to accelerate to the end position
according to the set speed (When the SLYPOD PRO extends to 520mm or retracts to 0mmit will
reach the setting speed)
● Acceleration Mode