Alienware AW3821DW 37.5" 1600p 144 Hz Curved Gaming Monitor - Manual (Page 36)

36 | Setting up the monitor
2. Connect the other end of the USB 3.2 Gen1 upstream cable to an
appropriate USB 3.2 Gen1 port on your computer.
3. Connect the USB 3.2 Gen1 peripherals to the USB 3.2 Gen1 downstream
ports on the monitor.
4. Plug the power cables for your computer and monitor into a wall outlet.
5. Turn on the monitor and the computer.
If your monitor displays an image, installation is complete. If it does not
display an image, see Common problems .
Removing the monitor stand
NOTE: To prevent scratches on the display when removing the stand,
ensure that the monitor is placed on a soft, clean surface.
NOTE: The following instructions are applicable only for removing the
stand that was shipped with your monitor. If you are removing a stand
that you purchased from any other source, follow the set up instructions
that were included with the stand.
To remove the stand:
1. Turn off the monitor.
2. Disconnect the cables from the computer.
3. Place the monitor on a soft cloth or cushion.
4. Carefully slide and remove the I/O cover from the monitor.