StarTech.com 5.25" Removable SATA Hard Drive/Mobile Rack Drawer (Black) - Manual (Page 6)

4
Installing the Drive Bay in the PC
1. Make sure that your system is unplugged and you are grounded.
2. Remove the side covers from your PC and remove the front cover from an available 5 1/4” drive
bay (see your computer’s user manual for details, if necessary).
3. a) By default, DRW150SAT/DRW150SATBK is configured for use with a SATA II drive. If you
wish to use a SATA (150) drive, move the switch on the rear panel to the rightmost position
(as illustrated below).
b) If you will be using a SATA (150) hard drive, please note that a connection must be made to
the motherboard in order to make use of the LED indicators on the host computer. Please
consult the documentation that was included with your motherboard/computer purchase to
determine individual connection requirements.
3. Insert the bay into the 5 1/4” bay slot, making sure that the screw holes on the side or bottom of
the bay line up with the holes in the bay slot.
4. Connect your computer’s cable ribbon to the connector on the back of the bay.
5. Plug a connector from your computer’s power supply into the power port on the back of the bay.
6. Using the supplied screws, mount the bay into the PC.
Caddy Bay
5 1/4” Bay
SATA/SATA II selector LED pin connection to motherboard
DRW150SATBK - Rear Panel