ProSoft Technology 5301-MBP-ASCII - Manual (Page 20)

Port Physical and Protocol Specifications MBP ♦ ProLinx Gateway
Protocol Manual Modbus Plus
Page 20 of 52 ProSoft Technology, Inc.
May 12, 2011
2.3 Hardware Specifications
Specification Description
Power Supply 24 Vdc nominal
18 Vdc to 32 Vdc allowed
Positive, Negative, GND Terminals
2.5 mm screwdriver blade
Current Load 500 mA maximum @ 32 Vdc maximum
Operating Temperature -4°F to 122°F (-20°C to 50°C)
Storage Temperature -40°F to 185°F (-40°C to 85°C)
Relative Humidity 5% to 95% (with no condensation)
Dimensions
(Height x Width x Depth) Standard: 5.20 in x 2.07 in x 4.52 in
(13.2 cm x 5.25 cm x 11.48 cm)
Extended: 5.20 in x 2.73 in x 4.52 in
(13.2 cm x 6.934 cm x 11.48 cm)
LED Indicators
(On all modules) Power and Hardware Fault
Configuration and Application Communication Status
Serial Configuration Port Activity and Error
Configuration
Serial Port DB-9M RS-232 only
No hardware handshaking
Ethernet Port
(Ethernet protocol modules
only) 10 Base-T half-duplex RJ45 Connector
Link LED and Activity LED indicators
Electrical Isolation 1500 Vrms at 50 Hz to 60 Hz for 60 seconds,
applied as specified in section 5.3.2 of IEC 60950: 1991
Ethernet Broadcast Storm Resiliency = less than or equal to 5000
[ARP] frames-per-second and less than or equal to 5 minutes
duration
Application Serial Port(s)
(Serial protocol modules
only) RS-232/422/485
RS-232 handshaking configurable
RS-422/485 DB-9 to Screw Terminal Adapter
Note: The number of serial application ports depends on the module
type, and the combination of protocols.
Serial Port Isolation 2500 Vrms port signal isolation per UL 1577
3000 Vdc min. isolation port to ground and port to logic
Shipped with Each Unit Mini-DIN to DB-9M serial cables
4-foot RS-232 configuration cable
2.5 mm screwdriver
CD (docs and configuration utility)
RS-422/485 DB-9 to Screw Terminal Adapter for each serial
application port (serial protocols only)