Silvercrest SEM 1100 A2 - Manual (Page 73)

71 SEM 1100 A2
GB
MT
Insert the sieve carrier 4) w into the appliance by placing it at the marking “IN-
SERT” and then turning it anticlockwise to the marking “LOCK”.
Place one (or two) cup(s) under the sieve carrier openings. We recommend 5)
that you rinse the cups out with hot water beforehand, so that the espresso
does not cool so quickly.
As soon as the green heating-up control lamp 6) 4 glows, you can turn the ro-
tary switch 5 to the position “ ”. The espresso fl ows into the cup(s).
WARNING
Never remove the sieve carrier w during the espresso output!
The resulting spray of hot espresso would lead to injury!!
Always ensure that the rotary switch ► 5 stands at " " before you remove
the sieve carrier w.
NOTICE
This appliance is fi tted with a pre-brew function. This means that the hot ►
water, before it is pressed through the espresso powder, stands for a short
time in the fi lter holder. This refi nes the aroma of the espresso.
When the cup(s) are fi lled to the desired quantity (about 20 ml), turn the 7)
rotary switch 5 back to the position “ ”.
You can now drink the espresso.
Switch the appliance off with the on/off switch 8) 3.
NOTICE
After 3 minutes the appliance will switch itself off automatically. ►
After every use remove the espresso powder from the espresso sieve 9) 0 q.
Remove the sieve holder w from the appliance. Flip the sieve blocker e
upwards so that the espresso sieve 0 q cannot fall out of the sieve holder
w. Now empty the espresso sieve 0 q. Always dispose of the espresso
powder or espresso pads in an environmentally friendly manner, for example,
with the organic waste.
NOTICE
Absolutely clean the hot water shower ► t after every use. Refer to the
chapter "Cleaning and Care".