iSys V8.5e Thermal Printer - Manual (Page 55)

55
VORSICHT: Bei der thermischen Plottertechnologie entstehen hohe Temperaturen. Ungeeignete Medien oder
falsche Kontrasteinstellungen können den Druckkopf oder andere Bauteile beschädigen und zu Verlust der Garantie
führen. Auch können
Beschädigungen an den Medien entstehen.
Form feed stops before desired length
Possible Cause: The form feed length is too short. The form feed stops before the paper sensor
can read the “top of form” mark.
Solution:
1. Adjust the FFLENGTH setting on the control panel as described in Chapter 4, Page 4-10.
Form feed does not stop at top-of-form marks
Possible Cause:
The top-of-form sensor is not reading the marks.
Solution:
1. Contact your authorized service center.
Plot is skewed or unreadable
Figure 7-8 Skewed plot
Possible Cause: The scan width is incorrect.
Solution:
1. Adjust the scan width (byte count) in your host software to 216 bytes or less.