iSys V8.5e Thermal Printer - Manual (Page 27)

27
Grayscale media table number
t1 - media calibration table for media 1.
t2 - media calibration table for media 2.
These tables have preset values for imaging on two different medias while in grayscale mode. These medias can
be changed for different medias by uploading new tables.
Setup headers for programming the V8.5e
NOTE: The V8.5E must be in PRINT mode for the setup header string to work. Numeric values shown below are
hexadecimal, not ASCII.
NOTE: All menu functions can be remotely configured by sending a setup header string from the host to the
V8.5E through the interface. The programmable advance past TOF can be programmed in a similar
fashion.
NOTE: Sending a 00 hex in any of the setup string positions listed below allows the menu item to remain
unchanged.
The format is as follows:
Byte 1: escape code =99
Byte 2: contrast C1=11 Lightest
C2=12
C3=13
C4=14
C5=15
C6=16
C7=17
C8=18 Darkest
No Change=00
Byte 3: speed 1”=21 1.0 inches/sec
2”=22 2.0 inches/sec
3”=23 3.0 inches/sec
4”=24 4.0 inches/sec
No Change=00
Byte 4: media LP=31 Light Paper
HP=32 Heavy Paper
LF=33 Light Film
HF=34 Heavy Film
No Change=00