H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 151)

11-16
Configuration prerequisites
UDP echo tests require cooperation between the NQA server and the NQA client. Before you start UDP
echo tests, configure a UDP listening service on the NQA server. For more information about the UDP
listening service configuration, see Configuring the NQA Server .
Configuring UDP echo tests
Follow these steps to configure UDP echo tests:
To do… Use the command… Remarks
Enter system view system-view —
Enter NQA test group view
nqa entry admin-name
operation-tag
—
Configure the test type as UDP
echo and enter test type view
type udp-echo Required
Configure the destination address
of UDP packets
destination ip ip-address
Required
By default, no destination IP
address is configured.
The destination address must be
the same as the IP address of the
listening service configured on the
NQA server.
Configure the destination port of
UDP packets
destination port port-number
Required
By default, no destination port
number is configured.
The destination port number must
be the same as that of the listening
service on the NQA server.
Configure the size of the data field
in each UDP packet
data-size size
Optional
100 bytes by default.
Configure the string to be filled in
the data field of each UDP packet
data-fill string
Optional
By default, the string is the
hexadecimal number
00010203040506070809.
Specify the source port of UDP
packets
source port port-number
Optional
By default, no source port number
is specified.
Configure the source IP address of
UDP packets
source ip ip-address
Optional
By default, no source IP address is
specified.
The source IP address must be
that of an interface on the device
and the interface must be up;
otherwise, no probe packets can
be sent out.
Configure optional parameters
See Configuring Optional
Parameters for an NQA Test
Group Optional