ZeeVee ZvBox 170 Front Panel - Manual (Page 5)

ZvBox ® 170 Configuration Manual Page 5
www.zeevee.com Rev 1.0
ZvBox® 170 Front Panel Dashboard
In normal operation the display panel on the ZvBox® 170 is in “Dashboard” mode, giving you at‐a‐glance
information about the operation of the ZvBox, as follows:
1 – HDTV channel #
2 – Short Channel Name
3 – Input Video Source
4 – Output resolution
In addition, status messages may scroll across the bottom line of the display in lieu of the ‘Input Video
Source’ and ‘Output Resolution’ indicators. These status messages are as follows:
Status message Notes
RF power off Turn RF power on to begin broadcasting
Scanning cable
ZvBox is scanning cabling for open and occupied RF
channels. Wait for completion.
VGA: no video input or
Component: no video No video input is detected at designated
connector‐ check source connection
VGA: resolution unsupported or
Component: resolution unsupported Input video resolution not supported by ZvBox.
Change to supported resolution.
VGA: 1080 unsupported or
Component: 1080 unsupported –
Input video resolution of 1920x1080 unsupported;
message appears at HDTVs as well. Change to
supported resolution.
Temperature critical or
Temperature warning
ZvBox is in danger of overheating; make sure all air
inlets and outlets are clear, and that nothing is
stacked on top of ZvBox
DSP error, reboot
The digital signal processor (DSP) is not functioning
correctly. Try rebooting the unit, or call technical
support.
ZvBox® 170 Front Panel Setup
The front panel buttons operate as follows:
• Next scrolls through available settings
• + and – buttons scroll through possible
values for a setting and multiple status lines
•
OK saves the selected value