MovinCool Classic 40 - Manual (Page 23)

23
INSTALLATION (cont.)
Optional Accessories and Set Up Configuration (cont.)
Outdoor Installation of the Unit (For Classic 40 and Classic 60)
The unit can be installed outdoors, sending the cool air indoor. More information
is available at WWW.MOVINCOOL.COM.
Note:
1. Make sure to run power and remote controller wires through conduit tubing.
2. Make sure to install a residual current operated circuit breaker in the power
supply.
3. Completely seal the through holes in the wall for conduit and duct to prevent
entry of rain. Use watertight fittings.
4. Do not place the unit directly on the ground. Install the unit at least 7 in. (178
mm) of clearance above ground. The optional standard stand kit (for Classic
40 ONLY) ensures a ground clearance of 7 in. (178 mm) or more.
DUCT SUSPENSION WIRE SEAL HERE TO PREVENT
ENTRY OF RAIN
BUILDING
WALL
STAND
KIT
DUCT
POWER BOX
WALL THERMOSTAT
POWER WIRES RUNNING
THROUGH CONDUIT TUBING
WALL THERMOSTAT WIRES
RUNNING THROUGH
CONDUIT TUBING
7 in. (178 mm)
OR HIGHER