About the remote control, Cautions on handling, Cautions on storing discs – Marantz SA11S3N User Manual
Page 11: Cleaning discs, Inserting the batteries, Operating range of the remote control
4
Getting started
Basic connections
Operation
Index
Explanation of terms
Troubleshooting
Specifications
ENGLISH
Getting started
Basic connections
Operation
Index
Explanation of terms
Troubleshooting
Specifications
Discs
Cautions on handling
• Do not get fingerprints, oil or dirt on discs.
• Take special care not to scratch discs when removing them
from their cases.
• Do not bend or heat discs.
• Do not enlarge the hole in the center.
• Do not write on the labeled (printed) surface with ball-point
pens, pencils, etc., or stick new labels on discs.
• Water droplets may form on discs if they are moved suddenly
from a cold place (outdoors for example) to a warm place, but
do not try to dry them off using a hairdryer, etc.
Cautions on storing discs
• Be sure to remove discs after using them.
• Be sure to store discs in their cases to protect them from
dust, scratches, warping, etc.
• Do not store discs in the following places:
1. Places exposed to direct sunlight for long periods of
time
2. Dusty or humid places
3. Places exposed to heat from heaters, etc.
Cleaning discs
• If there are fingerprints or dirt on a disc, wipe them off before
using the disc. Fingerprints and dirt can impair sound quality
and cause interruptions in playback.
• Use a commercially available disc cleaning set or a soft cloth
to clean discs.
Gently wipe the disc from the
inside towards the outside.
Do not wipe in a circular
motion.
NOTE
Do not use record spray, antistatic agents, benzene, thinner or
other solvents.
About the remote control
Inserting the batteries
q
Remove the rear cover of
the remote control.
w
Set two R03/AAA batteries
in the battery compartment
in the indicated direction.
e
Put the rear cover back on.
NOTE
• Replace the batteries with new ones if the unit does not
operate even when the remote control is operated close to
the unit.
• The supplied batteries are only for verifying operation.
• Insert the batteries in the proper direction, following the “q”
and “w” marks in the battery compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery with an old one.
• Do not use two different types of batteries.
• Do not attempt to charge dry batteries.
• Do not short-circuit, disassemble, heat or dispose of
batteries in a fire.
• Do not keep the battery in a place exposed to direct sunlight
or in places with extremely high temperatures, such as near
a heater.
• If the battery fluid leaks, carefully wipe the fluid off the inside
of the battery compartment and insert new batteries.
• Remove the batteries from the remote control if it will not be
used for a long time.
• Dispose of batteries in accordance with local regulations on
battery disposal.
• The remote control unit may function improperly if
rechargeable batteries are used.
Operating range of the remote control
Operate the remote control while pointing it at the remote
sensor.
Approx. 8 m
30°
30°
NOTE
• The unit may function improperly or the remote control may
not operate if the remote control sensor is exposed to direct
sunlight or strong artificial light from a fluorescent or infrared
light.
• When using 3D video devices that transmit radio
communication signals (such as infrared signals etc
.)
between the various units (such as the monitor, 3D glasses,
3D transmitter unit etc), the remote control unit may not
operate due to interference from those radio communication
signals. If this occurs, adjust the direction and distance of the
3D communication for each unit, and check that the remote
control unit operation is not affected by these signals.
1.SA-11S3N_ENG_Final_0525.indd 4
2012/05/25 17:13:59