Marantz Wizz.it 3 - Manual (Page 8)

6
ADD IR CODE WINDOW
y
q t w e r
q Learn IR
This is used to learn the remote control codes from other remote controllers and set them in the action
list. (Refer to page 7, Learning IR .)
w My Database
This loads and sets the IR codes registered in My Database. Specify the fi le saved in the PC to load
the IR codes registered in My Database.
e IR Database
This loads and sets the IR codes from the IR Database containing the remote codes from various
brands. (Refer to page 8, IR Database Window .)
r RC5/6
This uses direct key input to set the remote control codes RC-5, RC-5 Extension, RC-6 mode 0, RC-6
mode 6A used by Marantz. (Refer to page 9, Edit RC5/RC6 Window (Direct Input Code .)
t Test IR
This performs a test transmission of IR commands by sending a preset code from the remote controller
connected to the PC.
y Duration
This is used to adjust the duration of the IR command.
RC3001_E_Wizzit3_ENG.indd 6 RC3001_E_Wizzit3_ENG.indd 6 07.9.3 1:38:30 PM 07.9.3 1:38:30 PM