Kemppi Promig 540R - Manual (Page 3)

2 – Promig 540R, Promig 120R/0425
©
KEMPPI OY Promig 540R, Promig 120R/0423 – 3
©
KEMPPI OY
1. PREFACE
1.1. INTRODUCTION
Congratulations on having purchased this product. Properly installed Kemppi products should
prove to be productive machines requiring maintenance at only regular intervals. This manual is
arranged to give you a good understanding of the equipment and its safe operation. It also
contains maintenance information and technical specifications. Read this manual from front
to back before installing, operating or maintaining the equipment for the first time. For further
information on Kemppi products please contact us or your nearest Kemppi distributor.
Specifications and designs presented in this manual are subject to change without prior notice.
In this document, for danger to life or injury the following symbol is used:
Read the warning texts carefully and follow the instructions. Please also study the Operation
safety instructions and respect them when installing, operating and servicing the machine.
1.2 PRODUCT INTRODUCTION
Promig 540R is a welding system designed for robotic and automated welding. It consists of
Promig 540R with inbuilt robot interface and a robot arm mounted feed unit Promig 120R.
These two units are connected with an intermediate cable assembly.
Manual control is possible using interchangeable control panel:
MXE: Synergic MIG/MAG and Pulsed MIG in the most demanding welding environment.
MMA welding is also possible.
Welding operation is controlled by microprocessor. The wire feed motor includes an amplified
tachometer feedback system to ensure accurate wire feed speed. The interface stage handles
fieldbus signal covering all automated requirements.