Dataprobe T-APS Rack - Manual (Page 20)

SNMP Ethernet Port
The system can be managed by SNMP through standard management software. Dataprobe provides a
private MIB which is available on our web site at:
http://www.dataprobe.com/files/switch/taps/taps-r.mib
Traps can be programmed to respond to various application requirements as well a operational functions
set and system status retrieved.
Setting I/P Address
The T-APS comes with factory installed IP address 192.168.1.254. In most cases this will need to be
changed.
Consult your Network Administrator to determine the appropriate IP address. The IP address is changed
thru the Set Uo menu screen .
To set the IP address, the hardware (MAC) address must be known. This address is located on a label
on the back of the unit or can be accessed thru serial port. The syntax for the MAC address is: nn-nn-nn-
nn-nn-nn
IP Address, Subnet Mask and Gateway: Enter the appropriate information in dotted decimal format
(xxx.xxx.xxx.xxx). If you are unsure of the entries, consult your network administrator.