Baby Lock Spirit (BLPY) Instruction and Reference Guide - Manual (Page 57)

CONNECTING THE SENSOR PEN
Se
ns
or
Fu
nc
tion
s
Basic operations B-55
B
2 When connecting the sensor pen to the machine, make sure that the arrow on the sensor pen connector
faces up, lines up with the arrow on the machine, and that the connector is firmly inserted into the jack.
a Sensor pen jack
b Sensor pen connector
Using the Sensor Pen Holder
Before connecting the sensor pen to the machine,
attach the sensor pen holder to keep the sensor
pen with the machine.
The right side of the holder can be used to hold the
touch pen.
Sensor pen holder
a
Insert the point end of the cleaning brush or
the seam ripper point into the hole in the
protective cap on the right side of the
machine. Lightly pull out the protective cap
to remove it.
→ Insert the point of the seam ripper or cleaning brush
into the hole in the protective cap, and then lightly
pull out the protective cap to remove it.
b
Firmly insert the sensor pen holder into the
hole where the protective cap was
removed.
CONNECTING THE SENSOR PEN
CAUTION
• When connecting the sensor pen, make sure
that the arrow on the sensor pen connector
faces up and aligns with the arrow on the
machine, otherwise the connector pins will
not align correctly and the connector will be
damaged.
• When connecting or disconnecting the sensor
pen, grab the connector, and then slowly push
it straight in or pull it straight out.
• When disconnecting the sensor pen from the
machine, do not pull on the cord, otherwise
the sensor pen may be damaged.