Clock installation – American Time Wi-Fi Clocks User Manual
Page 6
© American Time
6
Wi-Fi Installation Manual
Clock Installation
Ap
pe
nd
ix
Tr
ou
ble
sh
oo
tin
g
Con
figur
at
io
n
Ho
mi
ng C
lo
ck
Fi
rmwa
re
Up
da
te
Fac
to
ry
D
efa
ul
ts
Re
st
or
e
Bu
tt
on
Op
er
ati
on
In
st
al
la
tio
n
In
tr
odu
ct
io
n
Sp
ec
ific
at
io
ns
Before installing verify:
• Dynamic Host Configuration Protocol (DHCP) settings
• Firewall port 123 is open for UDP data
• Good Wi-Fi coverage at intended installation location.
• Green gear locking pin (A) is removed from the movement
1. Adjustments/Configuration via limited access Point mode
If clock was preconfigured at American Time as recommended, skip to step 2.
Otherwise, refer to Button Operation and Configuration (Limited Access Point mode) sections to configure clock manually.
2. Apply power to the clock by inserting the barrel plug (C) of the battery pack into the left side of the Wi-Fi module where the
power connection is located.
n
Note: If green gear locking pin (A) has not been removed, remove it prior to applying power.
i. Verify the LED (B):
1. Flashes red when power is applied to the clock.
2. Flashes green within 60 seconds.
3. Green flash stops within 120 seconds.
ii. Verify the clocks hands begin to spin rapidly within 6 minutes after applying power.
iii. Verify the correct time on the clock within 20 minutes of applying power.
3. Place the clock on the wall using the hanger on the back of the clock or the optional security bracket (sold separately).
A - Green gear
locking pin
C - Battery pack
power input
B - LED