American Time Wi-Fi Clocks - Manual (Page 15)

15
© American Time
Wi-Fi Installation Manual
Homing Clock
Ap
pe
nd
ix
Tr
ou
ble
sh
oo
tin
g
Con
figur
atio
n
Ho
mi
ng C
loc
k
Fir
mwa
re
Up
da
te
Fac
tor
y D
efa
ults
Re
sto
re
Bu
tto
n
Op
er
ati
on
In
stal
la
tio
n
In
tro
du
ctio
n
Sp
ec
ific
atio
ns
If the clock is dropped it is possible for the clock hands to move from the correct placement. The Wi-Fi module can tell the
clock movement to go to 12 O’clock to verify hand placement is still correct.
To check hand placement complete the following process:
1. Apply power to Wi-Fi module by inserting the barrel plug of the battery pack into the left side of the Wi-Fi module where the
power connection is located.
2. Verify the LED starts flashing red.
3. Press and hold the button located on the middle of the Wi-Fi module.
a. The LED should turn solid green to indicated the button press (continue holding the button).
b. Wait for the LED to flash orange one time (do not release the button).
c. Wait for the LED to flash orange twice.
4. Release the button.
a. Verify the LED turns solid red.
b. Verify the LED turns solid orange.
c. Verify the LED flashes green.
5. Hands should begin moving rapidly within 30 seconds.
a. If not, remove power and start with step 1 again.
6. Wait for hands to stop moving (this may take up to 20 minutes).
7. Verify all three hands (second hand, minute hand and hour hand) stop at the 12 position.
a. If not, contact American Time technical support at 800-328-8996.
8. Power cycle Wi-Fi module by disconnecting barrel plug of the battery pack for 5 seconds and reconnecting.
A - Green gear
locking pin
C - Battery pack
power input
B - LED