American Time Wi-Fi Clocks - Manual (Page 17)

17
© American Time
Wi-Fi Installation Manual
Factory Defaults Restore
Ap
pe
nd
ix
Tr
ou
ble
sh
oo
tin
g
Con
figur
atio
n
Ho
mi
ng C
loc
k
Fir
mwa
re
Up
da
te
Fac
tor
y D
efa
ults
Re
sto
re
Bu
tto
n
Op
er
ati
on
In
stal
la
tio
n
In
tro
du
ctio
n
Sp
ec
ific
atio
ns
American Time preconfigures your clock settings prior to shipment to you. These preconfigured settings are stored in memory
even after settings have been changed.
n
Note: If your clock was not preconfigured at American Time, completing the factory defaults restore process will not help.
Refer to configuration section of this manual to reconfigure your clock.
To restore preconfigured settings complete the following process:
1. Apply power to Wi-Fi module by inserting the barrel plug of the battery pack into the left side of the Wi-Fi module where the
power connection is located.
2. Verify the LED starts flashing red.
3. Press and hold the button located on the middle of the Wi-Fi module.
a. The LED should turn solid green to indicated the button press (continue holding the button).
b. Wait for the LED to flash orange one time (do not release the button).
c. Wait for the LED to flash orange twice (do not release the button).
d. Wait for the LED to flash orange three times (do not release the button).
e. Wait for the LED to flash orange four times.
4. Release the button.
a. Verify the LED alternates red/green.
5. Wait 20 seconds.
6. Power cycle Wi-Fi module by disconnecting barrel plug of the battery pack for 5 seconds and reconnecting.